Kenwood TM-D710 low audio in echolink

Problem solved

On the TM-D710, the default output level on the PR1 pin is very low in EchoLink mode. Kenwood advises that it can be adjusted using the MCP-2A programming software, which is available free of charge from the Software Downloads page of the Support section of the Kenwood Web site. In the Data Terminal Adjustment section, increase the PR1 Output Level (EchoLink Mode) from 3 to a higher value such as 6 or 7. Note that this adjustment does not work correctly in version 3.01 of the MCP-2A software, but it should work in earlier and later versions.


I 've made my adjustment of the PR1 to 6 and it works like a charm!


73 de SV1JRF
 

Popular posts from this blog

Delta Loop Antenna 10m-11m + Balun 4:1

Image
As i really enjoy using the 10m band and sometimes the 11m band to talk with friends around Athens, it came as a must of constructing a new antenna. Also i wanted to do this because i have an Albrecht 5890EU ,which operates in these frequencies and i didn't have an extra antenna to operate it. Due to the lack of space in my QTH(that is why i 'm using the long wire + UnUn antenna), i was trying to find a solution of a vertical polarization antenna ,with high efficiency and as small as possible.
Read more

DVRPTR v1 - Repeater Interface Cable Schematic

Image
If you want to create a duplex repeater using the DVRPTR v1 ,you must construct a cable and also you will have to use two transceivers. The cable diagram is shown bellow. You will need 3x6pin mini din male connectors and 2m of ethernet cable cat 5. Of course from the cable you will only use 4 wires from 8.
Read more